Siser Brick - Navy Blue - 12" x 20" sheet

Need some "umph" in your HTV design. Siser's Brick 600 Navy Blue has some dimension/volume with a matte finish.. Siser's Brick 600 is best for smaller logos/designs.With its great flexibility Brick 600 will make your caps,bags,and shirts really stand out and call some attention!

siser's Brick 600     Applies to : 100% Cotton - Poly/Cotton blends -100%Polyester  - Lycra - Spandex

                        HOW TO APPLY BRICK 600 (HEAT PRESS):   *always do a test cut with any material your using 

                         -Cut  in reverse and weed design 

                   - Preheat garment for 2-3 seconds

                    -  use your cover sheet and place over your design

               - Apply design at 311*f/155*c with medium-firm pressure for 15/20 seconds

                - Peel carrier cold

HOW TO APPLY BRICK 600 (HOME IRON):  *always do a test cut with any material your using 

              - Set iron dial between Cotton and Linen
             -Cover design with Kraft paper or non-stick cover sheet
            -Place on flat, hard surface (ironing board not recommended)
        -Press iron with medium/firm pressure (do not slide iron)
    -Press each section of design for 10-15 seconds
       - If areas of design lift after application, replace cover sheet and re-press for 10 seconds
      - Peel carrier cold

   LAUNDERING:    - Wait 24 hours before first wash warm/cold mild detergent

                              - Do NOT bleach or dry clean 

                               - Hang item to dry