WebFLEX Matte Heat Transfer Vinyl
12" x 9" sheet of WebFLEX Matte HTV
- Clear Polyester
- 4 Mil
- Matte Finish
- 12" x 9"
Prior to application, preheat the garment for 10 seconds.
This flattens out wrinkles and eliminates moisture in the fabric.
Place the material into the cutter with the transfer carrier (shiny side) down.
Cut the logo, word or numbers in the reverse (mirror image).
Weed away excess material leaving the desired graphic on the carrier.
Position the weeded design on the garment with the carrier side up.
Place cover sheet or teflon sheet over graphic.
Apply heat for 12-15 seconds using light pressure.
The press should be set at 330 degrees F.
Peel the carrier while warm.
WEbFLEX does not have an adhesive backing making it possible to stack designs after being weeded.
Webflex is a made in USA product
Excellent heat transfer vinyl that weeds and cuts to very easy. Will buy from Ante Up Graphic again.
I love using there web flex and super fast shipping.
When I heated the product and went to remove the carrier sheet, the letters did not stay onto the shirt. It took about an hour for me to pull off each letter and place it correctly since the letters did not melt correctly onto the material (a grey cotton shirt).
-Sorry to hear that you had some trouble with this product.
The soft, matte finish of the pressed webFLEX is great! Looks really sharp. The non-adhesive carrier sheet can be a blessing and a curse. It weeded out beautifully, and I was able to stack all 36 sheets I was working with at once. However, if you accidentally pull up something you shouldn't have (inside of an A, or O for example) you can't put it back down on the carrier. I just had to keep track of the extra little bits until I was able to press them. Other than that I really love it!
This product worked great. I absolutely love the fact that the carrier sheet does not have adhesive. It weeded well and went on great. Will buy again.